Is It Possible To Replace The Attic Access Panel

Attic access doors can vary in size but 24x54 inches is the general standard.

Is it possible to replace the attic access panel.

The pull down attic access hatch cover is made of flammable material. If you have pull down attic stairs or an attic door these should be sealed in a similar manner. In existing homes air seal attic access and drop down stairs to minimize air leakage to and from unconditioned attic spaces. Inspect and repair or replace the existing attic door or hatch panel as needed.

If the attic access is located in an unconditioned part of the home such as a garage insulation and air sealing may not be needed. Pre made insulated attic stair covers are also available from local home improvement centers or on the web. The cost to install a standard 24 by 54 inch plywood access door is approximately 36. Weatherstrip the edges and put a piece of rigid foam board insulation on the back of the door.

After removing the old stair unit pry loose the trim boards surrounding the door with a hammer claw or a small crowbar. See the scope and description tab for additional instructions. More often however the attic access is located in a closet or hallway where there s a direct pathway for air to move between the unconditioned and conditioned spaces of the home. Some kits do not include the panel that covers the entrance to the attic.

If this is the case the project total will increase depending on the type of wood used. Treat the attic door like a door to the outside. Remove all wood gypsum board screws nails and fasteners until you are left with the exposed joists that form the rectangular opening. Recommend a qualified contractor replace or upgrade the access stairs as necessary.

In this video we show you diy folks how to repair a broken attic access panel door frame.