Installing Tar Paper Under Siding

Install all subsequent courses with the same overlap until the top edge of the paper is within 6 inches of the roof s peak.

Installing tar paper under siding.

You want any water that does get behind the siding to run down and never be allowed to get near any wood. Our new build house has been standing without siding for two years. Before applying roofing you ll need to cover the sheathing with roofing felt also often called tar paper most local codes call for using 30 pound felt. I am about to replace the weathered tar paper with two new layers of 15 felt before siding the house with cedar clapboards.

We re in the coastal rainforest of southeast alaska very wet. The house will have a rain screen gap made of strips of pt plywood. If you will be attaching the building paper with cap nails use a chalkline to mark the sheathing with the locations of studs. Another great installation tip is to make sure the first strip of tar paper is installed so it overlaps the top of the foundation at least an inch.

Check that it is level and aligned and drive staples or cap nails. Staple down the tar paper. In fact many builders disagree on the effectiveness of house wraps altogether and while some builders will only install 15 pound asphalt saturated felt paper underneath exterior siding others swear by plastic fabric house wraps such as typar or tyvek. Some roofers prefer to attach felt underlayment with 1 inch roofing nails or special nails with plastic washers but most codes allow staples which are easier to drive.

Position the next course of tar paper farther up the roof so that its lower edge overlaps the upper edge of the paper in the first course by 1 foot. I want to replace the tar paper but i can t find it at homedepot or lowes. Use tyvek over building felt under siding. The walls are intended to dry to the outside.

Tack the end of the paper to the wall using a construction stapler. I saw a new house with felt paper under the siding rather than tyvek.