Install Recessed Lighting In Existing Ceiling No Attic Access

Its wires are held inside an electrical box that is connected to a metal light can.

Install recessed lighting in existing ceiling no attic access.

Without an attic recessed lights must be installed from below the ceiling instead of the top. But some homeowners may be reluctant to install them if they don t have access to attic space above the room where they would like to have the can lights installed. Unfortunately though a retrofit installation for those of us without attic access can also get pretty expensive if you hire someone to do the work for you. Recessed can lights are flush mounted with the ceiling.

Watch the entire process step by step. Use an electronic stud finder to locate two adjacent rafters and mark a spot half way between them as the. Remodeling recessed lights also found on amazon pencil. The housings and trim themselves aren t that expensive i picked up some 4 halo retrofit can lights for about 17 each from lowe s and trim for about 20 each at home depot.

Insert the electrical cable into the cable clamp on the remodelling recessed light housing. Pull the end of the cable out of the wall by 6 inches with fish tape. Mark the spot on the ceiling where the recessed lighting fixture is to be installed. Run electrical cable through the ceiling from the recessed light hole over to the light switch hole.

How to install recessed lighting even without attic access materials needed. When the can is installed into the ceiling clamps on the side expand securing the fixture. Drill a 1 4 inch hole in the ceiling at the center of the proposed opening. If the area above the ceiling is a finished space you can insert a coat hanger or fish tape through hole to check for any obstructions.

If necessary go into the attic and make sure there are no wires pipes or ductwork behind the proposed opening. Remodeling recessed light housing is the required model for the project.