How To Install Deadbolt Lock On Door

Snap on the decorative outer plate.

How to install deadbolt lock on door.

Install the cylinder and thumb lever. Remove the deadbolt from its packaging and take out the instruction sheet with the template for marking the holes on the door. Thread any cables over the physical deadbolt and make the connections on the other side. Position paper template on door edge.

If your deadbolt has a keypad install it now following the manufacturer s instructions. Drill a hole through the edge of the door. Insert deadbolt into edge hole and mark its outline. Retract the deadbolt and install the thumb turn assembly.

Mark center holes on face and edge. Install the deadbolt lock about 44 inches above the bottom of the door. Attach the interior part of the deadbolt lock by inserting the two provided long screws through the interior plate the two screw holes in the bolt and into the exterior side of the lock. Mortise the area around the faceplate.

Hall closet bed bath lock door prep checklist f10 f40 on a standard pre drilled door you ll be done installing your passage lock in just minutes using only a tape measure and a phillips screwdriver. Chisel out mortise for deadbolt. You ll have to adjust the position a bit if you have a combination storm door so as not to interfere with the storm doorknob or lock. Drill edge hole with spade bit.

Drill holes and secure the strike plate. What you need to know to learn how to install a deadbolt lock mark the door place the template so the center of the deadbolt will be 6 in. Keep in mind that an electric drill is not recommended for installation as it can easily strip the screws and damage your lock. Choose a position on the door for the lock.

Screw deadbolt to edge of door. Drill from both sides to prevent splintering. Above the center of the doorknob. Cut a hole for the deadbolt.

Hand thread the screws then tighten them using a screwdriver or power drill. Drill face hole using hole saw. You can complete your deadbolt installation in just a few minutes with minimal tools tape measure and a 2 phillips head screwdriver are all you need.