Use shoe pockets to organize nerf guns.
How to hang nerf guns on your wall.
The combination of 2 hooks and 4 pegs worked well for achieving the perfect angle in his display.
This is so simple to build it will make you get up and start yours today.
We did fast forward through some parts with music.
Mount the pegboard to the wall with mounting screws or anchors.
Place the peg board hooks around the peg board and rearrange as needed to fit your nerf guns.
Materials needed for a nerf gun wall.
Usually used to attach wire to metal fence posts or you can try searching zarebasystems dot com.
We purchased baskets and lined with a tin mini loaf pan to hold our bullets and darts.
Measure and mark where you will need to hang your pegboard.
Will be used to hold the hog fencing to the wall.
Will be used to to hold each individual nerf gun.
Place one spacer onto each screw and while holding the peg board into place screw into each anchor.
Find the studs in your wall and screw the 1 2 pieces into the studs.
Hang nerf guns up on a pegboard.
Come down about 2 inches from that mark and mark that this is where you want to put the 1 2 boards.
Store nerf guns on a wire rack.
Place the plastic spacer behind the board and run the.
Hanging nerf guns 1.
Start by figuring out where your pegboard is going to go and that it fits.
The squares are designed to be screwed in the pre indicated holes right into the studs.
Six squares worked out nicely for his nerf wall.
Then o man had a blast arranging and rearranging all of his nerf guns until they hung exactly as he liked them.
Usually used to hold electronic cables in place wall anchors.
Spray your pegboard in your choice of paint color.
So sit back relax and watch.
Measure where you want the top of the pegboard to be and mark it.
This takes very little time and we did two coats to get an.
Do the same for the bottom mark where your board will end come up about 2 inches and mark this.
Place pegboard against wall and mark with a pencil where your screws will go.
Pre drill your holes for the drywall screws then use the screwdriver to install the drywall screw.
Space out 2 pegs at.
