How To Hang Cork Board On Wall Without Nails

If you d like to hang a cork board but still want the option to take it down whenever you want without worrying about the damage you can use foam mounting strips.

How to hang cork board on wall without nails.

A layperson might think that it is a simple task to hang a dartboard on a wall. Remove the paper covering each strip of mounting tape. Clean the wall with a clean cloth and isopropyl alcohol. Pick up the cork board and align it with the line you drew in pencil.

However this task involves more than just hammering a nail into a wall and then placing the dartboard on the nail. Cork boards can be really useful when hung up for easy access but if you use nails or brackets to mount them you could end up damaging the wall. There are several other factors which you need to consider before hanging a dartboard up. Clean the wall where you will hang the board with a rag and rubbing alcohol to remove dirt debris and oils from the wall.

Drill holes and hang the pegboard use a stud finder or other means to locate the studs behind the drywall. How to hang a bulletin board without nails. Collecting art is a lot of fun but hanging it when you get home is a little more complicated. Press the cork board against the wall and hold it there for 30 seconds giving the adhesive time to work and become stable.

Measure the bulletin board from side to side and top to bottom. Place two strips of heavy. You ll be hanging the artwork on the hook with hardware that s attached to the back so you won t need to remove anything unless it prevents the picture from hanging flat against the wall. Using a level to ensure a 90 degree angle hold the pegboard in place on the wall you may need a friend to assist.

How to hang cork board without damage to the wall. Remove the paper liner from the back of the adhesive and press firmly against the wall for 30 seconds. You ll find yourself with a hammer in hand looking at your pristine walls and wondering is there any way i can hang artwork. Use a pencil to leave visible alignment marks above where the pegboard will be.

Measure the width of the cork board using a measuring tape. Wash the wall where you wish to hang the cork board using warm soapy water. Use this measurement to make a small mark on the wall.