Cut four medium length lengths of wire.
How to hang a mirror on a wall with wire.
Determine the middle of the line you have made.
Take the wire in your picture and hold it taut from the center to measure the distance from the top of wire to the frame.
Cut a piece of picture hanging wire with wire clippers that is twice that.
Take a small piece of wood approximately 12 inches 30 cm long and mark its center.
Hang a mirror using hooks step 1 hold the mirror in place close to eye level.
Then place marks to the left and right of this mark a distance that is equal to 1 4 of the total distance between the d rings.
Repeat for both spots where the wire connects with a d ring.
Hold the d rings over the pilot holes and secure them with small screws.
Measure the width of the mirror and add 6 inches.
Use pieces of scrap wire to reinforce the hanging wire.
For a large mirror start around 12 inches a standard ruler and adjust from there.
Wrap a length of scrap wire tightly around the hanging wire several times and crimping it closed with pliers securing it to one of the screw eyes.
Center it under the top of the mirror and hold it up tight under the wire until the wire is taut.
Mark the wall near the center of the top edge with a pencil or painter s tape.
Set the mirror down.
Mark the location of the top edge and the center of the frame.
Use a tape measure to measure the distance from the top of the mirror to the top of the piece of wood.
You don t want them too close together.
D rings and picture wire the mirror must have a frame around it to hang a mirror this way.
Measure the width of your mirror and mark a point in the middle of that line.
Place a scrap piece of wood that is approximately half as long as the mirror is wide underneath the hanging wire on back of the frame.
With the mirror propped against the wall or lying face down raise the wire up to make it taut and identify two points that will distribute the pressure equally across the wire.
Place the level against the wall at the place you want to hang the mirror and make a line on the wall with a pencil all along the top of where the mirror top will be.