How To Fix Sliding Folding Closet Doors

Hold the brace along the door edge with the triangular area on the back of the door.

How to fix sliding folding closet doors.

Tap the pin back in the hole with a hammer and mount the door in its brackets. Once the door is approximately under the hole in the track release the pivot. Close the wood with a c clamp and leave the clamp on for 3 to 4 hours. Remove a door by lifting and tilting the bottom out.

Then mark the anchor pivot pin hole centerlines. Spread the crack slightly with the screwdriver and spread carpenter s glue with a toothpick. Sliding closet doors fall off tracks. To clean and lubricate the hardware of a sliding closet door use a stiff brush a toothbrush or a hand vacuum to clean dust from the tracks.

Take down the door and pry the pivot out of the door edge with a flat head screwdriver or pliers. Slam a bifold door too many times and you can split the wood where the top and bottom anchor and pivot pins sit. If you have a sliding closet door that glides on a bottom track clean the track with a damp cloth to ensure smooth gliding. Lubricate the rollers but not the track because lubricant will act as a magnet for dust.

Use an aerosol lubricant to lubricate all the door rollers. If you see an uneven gap it will require you to raise or lower one of the sides. Bi fold closet doors are some of the most used doors in your house. Then retighten the screw close the doors and check the fit.

Stand back five feet or so and examine the gaps on the top and bottom. First check the alignment of your closet doors. There should be an even and uniform separation all the way along the top and bottom. Loosen the set screw on the top bracket and slide the bracket slightly along the track to adjust the space between the top of the doors.

Close the door and again. Watch to the end if you want to see the fun part. If the rollers are damaged install replacement rollers available at home centers. Tighten the set screw.

If a roller is stuck unscrew and remove it. Every home repair must end in fun. Repairing bifold doors begin by inserting the bottom pivot into the bracket which can be screwed to the floor to the door jamb or both.